By Eric Meyer

While planning for your wireless network you might be asking what is the difference between a router and an access point. You need to think of a router as more of a server because it performs many functions like a server. An access point only provides a portal for wireless client to connect to your existing LAN.

Routers can perform many functions. Routers can connect many different WLANs together acting like a traffic cop. Routers also act as a DHCP server. A DHCP server assigns dynamic IP address to your computer every time your computer starts up. If you don’t have a DHCP server then you will have to assign each computer on your network a permanent IP address.

As I have said before your router can also act like a traffic cop. You can use a router to perform port forwarding to certain computers on your LAN. For example you can direct all internet traffic looking for your game server’s port number to a specific computer on your LAN.

The ability to connect multiple computers to the internet is one of the main features of a router. The router is assigned one WAN IP address from your ISP. This IP address is called a public IP address that everyone on the internet can see. Because you have multiple computers connected to your router the router uses a protocol called NAT {Network address translation} NAT will assign the computers that are behind your routers IP address, private IP addresses. NAT acts as a firewall because computers on the internet cannot in theory even see your computers. They will only see the IP address of your router. NAT does block traffic from reaching your computers but it will not block Trojans from going out to the internet. That is why I do recommend installing a firewall on your LAN computers.

The role of an access point on a LAN is to give the wireless user a door way to enter. The more people that enter the door at the same time the slower they will go. 802.11b access points say they will give you a through put rate of 11mps but the actual rate is around 5MPS. 802.11g has a rating of 54mbps with an actual through put of 20mbps. The access points do have most of the same security features as a router such as WEP, WPA, 8021x and TKPI but they will not have the traffic cop functions like a router. Also the access points will not have NAT which would add an unnecessary layer to your network. To keep it simple access points just simulate plugging in your laptop to a port in the wall and that’s it.A router is used on the border of you network to act as a traffic cop deciding who can come in and blocking those you want to keep out.

Eric "The Wireless Ninja" Meyer is an expert in Wireless Networking. You can view other Wireless Networking articles at http://www.wirelessninja.com

Article Source: ArticleSlash.net

Routers Articles

A Quick Note From The Publisher... If you like the article above, you may be interested in the following article which is also related to Routers... What Is Wardriving And How Can You Prevent It Imagine a car equipped with nothing more than a laptop computer, a portable GPS receiver, and a wireless network card slowly strolls through your neighborhood. Unknown to any onlookers, this is no ordinary vehicle; rather, it is a wardriving machine. As the car strolls past homes and businesses, a wireless network card (available at any electronics store for as low as $25) scans for any wireless access points. Anyone with a wireless network (and there are many out there) is vulnerable. The computer is looking for what is called an SSID. An SSID is your wireless network name and it is being constantly transmitted by your access point, letting computers know of its presence. The wardriver uses software such as Netstumbler (for windows) or Cismet (for linux) to scan the airwaves for SSIDs. The program can track various access points at once and monitor the signal strength. These programs can also check to see if the network is encrypted. The wardriver will generally configure his or...

Routers, Computer Networking News